AGFA Avantra 36/44 Service Manual page 496

6. Lift the base of the boom into the adapter/mount. Route the power cable
exiting the boom base down through the mount center. Refer to Figure 1-4.
7. Lower the boom into position until the boom fits snugly into the adapter/
mount. Refer to Figure 1-4.
8. With the boom/adapter in place in the mount, connect the boom power
cable to the matching plug at the OLP. Refer to Figure 1-4.
5
Figure 1-4 Crane power cable connections.
–Electrical cable with connector.
–Mount. –Mounting bracket.
Section V: Crane
3
4
Mounting 1-5