AGFA Avantra 36/44 Service Manual page 450

Avantra 36/44 Service Manual
4.5.1.1 Problem Codes
1.0 When Switching On Main Power
1.1 No display information.
1.2 No LED indicators turned on.
1.3 No fan motor.
(After switching on at the control panel.)
2.0 developer Bath
2.1 Temperature in bath too high compared to preset.
2.2 Temperature in bath too low compared to preset.
2.3 Temperature increases too slowly.
2.4 Temperature correct but displayed temperature does not correspond to
thermometer reading.
2.5 Bath temperature fluctuates even though setting has not been changed.
3.0 Fixer Bath
3.1 Temperature in bath too high compared to preset.
3.2 Temperature in bath too low compared to preset.
3.3 Bath temperature fluctuates even though setting has not been changed.
4.0 Dryer Temperature
4.1 Temperature of exit air too high compared to preset.
4.2 Temperature of exit air too low compared to preset.
4.3 Dryer fan does not stop when film runs out.
4.4 Dryer fan does not start when the processor is in operation mode.
4.5 Temperature fluctuates even though setting has not been changed.
5.0 Replenishment
5.1 Replenishment pump relays are activated but no replenishment is
pumped.
5.2 Wrong amount of developer or fixer replenishment is pumped compared
to usage and preset amount.
5.3 Wrong oxy. replenishment compared to preset.
5.4 Wrong Agfastar timer replenishment compared to preset.
6.0 Main Motor and LUTH Motor Board
6.1 Motor does not run.
6.2 Motor consistently runs at high speed.
6.3 Fuses on PCB blow immediately when power is turned on.
6.4 Motor fluctuates in speed.
6.5 Incorrect developer time.
4-18 Maintenance
Table 4-2 Problem codes.