6. Gently squeeze the side of the remaining two (2) plastic stand-offs while
pulling the board(s) free from each stand-off.
1
2
3
Figure 4-22 The take-up and supply sensor driver modules (SDMs).
–SDM modules. –Three 3/16" hex screws. –Plastic shield.
–Two 1/4" hex screws.
Replace:
1. Push the SDM(s) back onto the two (2) stand-offs and secure with the two
(2) 1/4" hex screws.
2. Connect all cables removed in previous steps.
3. Launch the AVDIAG program from your PC and ensure that all functions
work properly for the SDM (supply or take-up) being replaced.
The following lists the functions that should be tested for each type.
–Two plastic standoffs.
Supply
Take-Up
Swap Spindle
Open/Close Nips
Supply Motor
T-U Motor
Supply Punch
T-U Punch
Section I: Imagesetter
4
Removal and Replacement 4-33
5