AGFA Avantra 36/44 Service Manual page 258

6.2.1.3 Spin Motor Mirror Cleaning Procedure
The following procedure insures that the spin motor mirror is clean. This
prevents a reduction in the amout of laser light that exposes the media on the
drum surface. Perform this procedure at each preventative maintenance call.
Tools Required: Optic Pads (P/N 78047-002), allen wrench
1. With the system's power off, open the left side and remove the drum light
shield.
2. Gently slide the carriage toward you to allow optimum access to the spin
motor.
3. Remove the left shroud assembly by disconnecting the brush solenoid
cable and loosening the four thumb screws.
4. Using an optic pad, wipe the mirror with a single stroke. Wipe the surface
again in the same manner with a clean section of the optic pad.
NOTE: Do not scrub/stroke the mirrored surface back and forth or
reuse a contaminated section of an optic pad.
5. Inspect the mirror. Insure that all contamination and streaking has been
removed from mirrored surface.
6. Repeat Step 4 as necessary until clean.
7. Re-install the left shroud assembly.
6.2.1.4 Punch Remnants
The Avantra 36/44 has two sets of punches. One on the take-up side (5-hole),
and the other on the supply side (1 hole). Each punch has its own remnant
container to catch the punched out media. Empty the containers at each PM call .
Tools Required: None
To Empty the Take-up Side:
1. Open the top cover.
2. Remove the front top and middle covers.
3. Remove the take-up light shield by loosing the three thumb screws.
4. Lift the punch remnant container from the system. Empty the container.
5. Replace the punch container, panel and covers.
To Empty the Supply Side:
1. Open the top cover.
2. Move the bridge to light mode. Lift the bridge to the up position.
3. Open the left side cover and remove the rear access panel by pushing up
on the three white buttons. Remove the access panel.
Section I: Imagesetter
Maintenance 6-3