AGFA Avantra 36/44 Service Manual page 145

Avantra 36/44 Service Manual
1. Insert the floppy disk with the new "DQ" and "L" files into your PC floppy
drive. Once you launch the program you will be asked three questions:
1. Serial number of the system.
2. Supported Engine Type. (What engine are you creating this
3. Version Number of the Correction Table.
2. To create the new Correction Table type the Avdiag directory name that
you installed the software in your PC. Do not launch the program from
Avdiag. For our example we will use the Avantra directory.
NOTE:
Use -ib: if floppy is in "B" drive of your PC.
This message displays on the PC:
NOTE:
The Version number may change depending on the version
of the Correction Utility program loaded in your PC.
3. Enter the machine serial number (leading zeros not needed).
4. Enter the engine type, from the table below:
1 Avantra - 25 @ 20K
2 Avantra - 36/44 @ 13.5K
3 Avantra - 25revC @ 20K
4 Avantra - 30 @ 20K
5 Avantra - 30 @ 30K
6 Avantra - 36/44 @ 20K
7 Avantra - 25 @ 30K
These messages will appear on the PC:
PROCESSING DENSITY FILES
Using program defaults fit constraints
Using program defaults correction coefficients
OK to delete existing D-files? (Y/N)
3-58 Diagnostics
correction table for?)
C:\Avantra> corrutil.exe -ia:
Avantra Corrutil Version 3.06
(for AV20/25 with DEC. "B" boards).
(for standard AV36/44 systems).
(for AV20/25 with DEC. "C" boards).
(no AV30s with 20K spin motors).
(AV30 with 30K spin motors).
(for Avantra 36/44 "S" systems).
(for Avantra 25 "S" systems).