Replace:
1. Reverse the removal procedures to re-install the supply drive motor.
NOTE: Ensure that the supply drive motor gear is positioned in the
center of the supply drive roller gear.
2. Turn the system on and launch the AVDIAG program from your PC.
3. Test spindle swap and supply motor.
4.7.2 Supply Cassette A or B Rewind Motors
Tools Required: 3/16" and 1/16" allen wrenches
Remove:
1. Follow the first eight steps in Section 4.7.1, Supply Drive Servo Motor
above.
2. Remove the red wire from Pin 1 and the black wire from Pin 2 at the end
of the supply motor (A or B) being replaced. Refer to Figure 4-44.
5
Figure 4-44 Removing the supply cassette A or B rewind motors.
–Red pin. –Black pin. –Two 1/16" allen screws. –Motor shaft.
–Gear. –Three 3/16" hex screws. –Bracket.
Section I: Imagesetter
3
4
1
2
7
6
Removal and Replacement 4-61