3. Standing in front of the imagesetter, remove the three (3) shoulder screws
(top, bottom and side) on the cover hinge. Refer to Figure 1-2.
2
3
Figure 1-2 The gas shock shoulder screws.
–Hinge. –Gas shock retaining bolt. –Gas shock.
–Top and bottom shoulder screws (remove).
4. Drop the top cover down.
5. Standing at the rear of the imagesetter, loosen the two (2) hex head screws
from the hinge assemblies, left and right. Refer to Figure 1-3.
6. Slide the bracket out. Refer to Figure 1-3.
Figure 1-3 The top cover hinge assembly.
–Top cover hinge assembly.
1
4
–Side shoulder screw (remove).
1
–Two hex screws (loosen).
Section II: Bridge
5
2
Installation
1-3