Crane Motor - AGFA Avantra 36/44 Service Manual

2.2.2 Crane Motor

Tools Required: Phillips head screwdriver, flat head screwdriver, 9/64" hex
wrench, 5/32" allen wrench
Remove:
1. Using the on/off switch, lower the crane cable as far as possible.
2. Using a phillips head screwdriver, remove the four (4) screws on the front
and back cover of the head.
3. Disconnect the power cable at the end of the head.
4. Using a flat head screwdriver, remove the three (3) screws in the end stop
at the front of the boom. Figure 1-6.
5. Carefully roll the head off the boom rails. Figure 1-6. Lay the head down
on a flat surface with the top (open) end up.
.
Figure 2-6 Boom rails and end stop.
– –
Boom rail. End stop.
Section V: Crane
1
2
Removal and Replacement 2-7