Avantra 36/44 Service Manual
1
2
Figure 1-12 Removing the tie down bracket.
–Bridge tie down bracket. –Four hex screws. —Supply tray.
WARNING:
'light mode.' To initiate light mode, the imagesetter must first be
turned on.
5. Lift the bridge and the upper light shield.
6. Remove the front top panel. See Chapter 4, Section 4.2.2, Top, Middle, and
Bottom Front Panels, for removing the front panels.
7. Locate the lower media transport Retainer Bracket (black) in the lower left
of the exposed unit. Remove the two (2) bracket hex screws. Refer to
Figure 1-13.
1-16 Installation
Do not lift the bridge unless the system has been put in