Brake Disc Inspection; Front Master Cylinder - Honda CBR650F Service Manual

dummyhead dummyhead
HYDRAULIC BRAKE
Make sure the pad spring [1] is installed in position
(page 18-14).
Be sure the stopper ring [2] on the pad pin is in good
condition, and replace it with a new one if necessary.
Coat the stopper ring with silicone grease.
Install the pads [3] so that their ends are rest on the pad
retainer [4] properly.
Lower the caliper body and loosely install a new caliper
bolt [5].
Install the pad pin [6] by pushing the pads against the
pad spring to align the pad pin holes in the pads and
caliper body.
Tighten the caliper bolt to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the pad pin to the specified torque.
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)
Operate the brake pedal to seat the caliper piston
against the pads.

BRAKE DISC INSPECTION

Visually inspect the brake disc for damage or cracks.
Measure the brake disc according to HYDRAULIC
BRAKE SPECIFICATIONS (page 1-9) and replace if
necessary.

FRONT MASTER CYLINDER

REMOVAL/INSTALLATION
Drain the brake fluid from the front brake hydraulic
system (page 18-5).
Remove the following:
When removing the
oil bolt, cover the
– Brake light switch connectors [1]
end of the brake
– Oil bolt [2]
hose to prevent
– Sealing washers [3]
contamination.
– Brake hose [4]
18-8
[1]
[3]
[5]
CBR650F/FA shown:
[3]
[2]
[4]
[4]
[2]
[6]
[1]