Frame; Handlebar - Honda CB160 Shop Manual

IV FRAME
4. I Handlebar
A. Construction of handlebar
The complete handlebar is made of pipe and is
installed on the front fork top bridge by the pipe
holder. The fork top bridge is mounted on the front
cushion by two front fork bolts. In edition, every
wire unit is exposed for making handlebar replacement
easy. (Refer to Fig. 4.
I)
B. Disassembly
I . Tools required for disassembly and assembly of
the handlebar.
(Refer to Fig. 4. 2)
2. For disassembling the front brake cable, turn the
front brake arm counterclockwise (where the brake
is effective), and remove the end of the cable.
(Refer to Fig. 4. 3)
3. For disassembling the clutch cable, loosen the
three small cross point screws of the drive chain
cover and remove the end of the cable from the
clutch adjustment thread.
4. For disassembling the throttle cable, loosen and
remove the carburetor cap : the throttle valve can
be pulled out. Remove the cable end from the
throttle valve.
(Refer to Fig. 4. 4)
53
SPEEDOM TER ASSEMBLY
fig. 4.
I Turning the handlebar
fig. 4. 2
Tools required for disassembly and assembly
Fig. 4. 3
Removing broke cable
fig. 4. 4
Removing coble end from the throttle valve