Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 19

Chapter 14
Configuring Inverse ATM1 or ATM2 ARP .....................................................326
Defining the ATM Traffic-Shaping Profile .....................................................326
Configuring ATM CBR ...........................................................................328
Configuring ATM2 IQ Real-Time VBR ....................................................328
Configuring ATM VBR ...........................................................................329
Specifying ATM1 Shaping Values ..........................................................329
Example: Specifying ATM1 Shaping Values ....................................331
Specifying ATM2 IQ Shaping Values .....................................................332
Configuring the ATM1 Queue Length ...........................................................333
Configuring the ATM2 IQ EPD Threshold ....................................................334
Example: Configuring the ATM2 IQ EPD Threshold ..............................335
Configuring Two EPD Thresholds per Queue ...............................................336
Configuring the ATM2 IQ Transmission Weight ...........................................336
Defining the ATM OAM F5 Loopback Cell Period .........................................337
Configuring the ATM OAM F5 Loopback Cell Threshold ..............................337
Configuring ATM Interface Encapsulation ....................................................338
Configuring an ATM1 Cell-Relay Circuit .......................................................340
Example: Configuring an ATM1 Cell-Relay Circuit .................................340
Configuring PPP over ATM2 Encapsulation .................................................342
Example: Configuring PPP over ATM2 IQ Encapsulation .......................343
Configuring E3 and T3 Parameters on ATM Interfaces ................................345
Configuring SONET/SDH Parameters on ATM Interfaces .............................346
Configuring ATM2 IQ VC Tunnel CoS Components ......................................347
Configuring Linear RED Profiles ............................................................348
Configuring an ATM Scheduler Map ......................................................349
Enabling Eight Queues on ATM2 IQ Interfaces ......................................350
Example: Enabling Eight Queues on T Series, M120, and M320
Platforms .................................................................................351
Configuring VC CoS Mode .....................................................................356
Enabling the PLP Setting to Be Copied to the CLP Bit ............................356
Configuring ATM CoS on the Logical Interface ......................................357
Example: Configuring ATM2 IQ VC Tunnel CoS Components ...............357
Example: Configuring ATM1 Interfaces .......................................................358
Example: Configuring ATM2 IQ Interfaces ...................................................360
Configuring ATM-over-ADSL Interfaces
ATM-over-ADSL Overview ...........................................................................363
Configuring Physical ATM Interfaces and Logical Interface Properties for
ADSL .....................................................................................................364
Configuring the ATM-over-ADSL Virtual Path Identifier ................................365
Configuring the ATM-over-ADSL Physical Interface Operating Mode ...........365
Configuring the ATM-over-ADSL Physical Interface Encapsulation Type ......366
Configuring the ATM-over-ADSL Logical Interface Encapsulation Type ........366
Configuring the ATM-over-ADSL Protocol Family .........................................367
Configuring the ATM-over-ADSL Virtual Channel Identifier ..........................368
Table of Contents
363
xix
Table of Contents