Table of Contents
Advertisement
Services
Repeat this step to list additional firewall zones.
6. (Optional) Set the amount of time that the TX54 device will wait between updating location
information, and sending location information to a destination server:
(config)> service location interval value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config)> service location interval 600s
(config)>
The default is 10 seconds.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Enable or disable the internal GNSS module
The internal GNSS module is enabled by default. You can disable it, or you can enable it if it has been
disabled.
Note
In order for the GNSS module to be able to provide location information, you must connect an
antenna to the GNSS antenna connector.
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
Location information
434
Advertisement
Table of Contents
