Configure Options For The Event And System Logs - Digi TX54 User Manual

Diagnostics
n
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure options for the event and system logs

The default configuration for event and system logging is:
The heartbeat interval, which determines the amount of time to wait before sending a
n
heartbeat event if no other events have been sent, is set to 30 minutes.
All event categories are enabled.
n
To change or disable the heartbeat interval, or to disable event categories, and to perform other log
configuration:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
To disable informational event messages:
(config system log remote 1)> info false
(config system log remote 1)>
To disable status event messages:
(config system log remote 1)> status false
(config system log remote 1)>
To disable informational event messages:
(config system log remote 1)> error false
(config system log remote 1)>
Configure options for the event and system logs
707