Table of Contents
Advertisement
Services
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the GNSS module:
To enable the module:
n
(config)> service location gnss true
(config)>
To disable the module:
n
(config)> service location gnss false
(config)>
4. (Optional) Set the port number that should be used to listen for location messages.
(config)> service location port port_num
(config)>
where port_num is the port number of the listenting port. The default is 2948.
5. (Optional) Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service location acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service location acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the TX54 device:
n
(config)> add service location acl interface end value
(config)>
TX54 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the service-type.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the service-type.
Location information
432
Advertisement
Table of Contents
