Digi TX54 User Manual page 204

Hotspot
6. Change the default SSID, Digi Hotspot, to your preferred value.
7. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change the SSID for digi_hotspot_ap (single-Wi-Fi models) or digi_hotspot_ap1 (dual-Wi-Fi
models) to your preferred value:
(config)> network wifi ap digi_hotspot_ap1 ssid value
where value is a string of 1 to 32 characters. If the value contains spaces, enclose in quote
marks (").
4. (Dual-Wi-Fi models): Change the SSID for digi_hotspot_ap2 to your preferred value:
(config)> network wifi ap digi_hotspot_ap1 ssid value
where value is a string of 1 to 32 characters. If the value contains spaces, enclose in quote
marks (").
TX54 User Guide
Hotspot configuration
204