Digi TX54 User Manual page 702

Diagnostics

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use show log
> show log
Timestamp
--------------
--
Nov 26 21:54:34
Nov 26 21:54:35
...
>
3. (Optional) Use the show log number num command to limit the number of lines that are
displayed. For example, to limit the log to the most recent ten lines:
> show log number 10
Timestamp
--------------
--
Nov 26 21:54:34
Nov 26 21:54:35
...
>
4. (Optional) Use the show log filter value command to limit the number of lines that are
displayed. Allowed values are critical, warning, info, and debug. For example, to limit the
event list to only info messages:
> show log filter info
Timestamp
---------------- ------- --------- ----------------------------------------
---
Nov 26 22:01:26
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
name=admin~service=cli~state=closed~remote=192.168.1.2
...
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
at the Admin CLI prompt:
Message
-----------------------------------------------------------
TX54 netifd: Interface 'interface_wan' is setting up now
TX54 firewalld[621]: reloading status
Message
-----------------------------------------------------------
TX54 netifd: Interface 'interface_wan' is setting up now
TX54 firewalld[621]: reloading status
Type Category
info user
info user
Message
View system event logs
702