Table of Contents
Advertisement
Virtual Private Networks (VPN)
c. Type the Username and Password that the device will use to authenticate as an
XAUTH client with the peer.
16. (Optional) Click Enable MODECFG client to receive configuration information, such as the
private IP address, from the remote peer.
17. Click to expand Local endpoint.
a. For Type, select either:
n
n
b. Click to expand ID.
i. Select the ID type:
18. Click to expand Remote endpoint.
a. For Hostname, select either a hostname or IP address. If your device is not configured to
initiate the IPsec connection (see IKE >
keyword any, which means that the hostname is dynamic or unknown.
b. Click to expand ID.
i. Select the ID type:
TX54 User Guide
Default route: Uses the same network interface as the default route.
Interface: Select the Interface to be used as the local endpoint.
Auto: The ID will be automatically determined from the value of the tunnels
n
endpoints.
Raw: Enter an ID and have it passed unmodified to the underlying IPsec stack.
n
For Raw ID value, type the ID that will be passed.
Any: Any ID will be accepted.
n
IPv4: The ID will be interpreted as an IP address and sent as an ID_IPV4_ADDR
n
IKE identity.
For IPv4 ID value, type an IPv4 formatted ID. This can be a fully-qualified
domain name or an IPv4 address.
IPv6: The ID will be interpreted as an IP address and sent as an ID_IPV6_ADDR
n
IKE identity.
For IPv6 ID value, type an IPv6 formatted ID. This can be a fully-qualified
domain name or an IPv6 address.
RFC822/Email: The ID will be interpreted as an RFC822 (email address).
n
For RFC822 ID value, type the ID in internet email address format.
FQDN: The ID will be interpreted as FQDN (Fully Qualified Domain Name) and
n
sent as an ID_FQDN IKE identity.
For FQDN ID value, type the ID as an FQDN.
KeyID: The ID will be interpreted as a Key ID and sent as an ID_KEY_ID IKE
n
identity.
For KEYID ID value, type the key ID.
Auto: The ID will be automatically determined from the value of the tunnels
n
endpoints.
Raw: Enter an ID and have it passed unmodified to the underlying IPsec stack.
n
For Raw ID value, type the ID that will be passed.
Any: Any ID will be accepted.
n
Initiate
connection), you can also use the
IPsec
296
Advertisement
Table of Contents
