Digi TX54 User Manual page 170

Wi-Fi
6. Set the security for the access point to none :
(config)> network wifi ap digi_ap1 encryption type none
(config)>
7. (Optional) Change the Wi-Fi radio for the access point (dual-Wi-Fi models only):
a. Show available radios:
(config)> network wifi radio ?
Additional Configuration
-----------------------------------------------------------------------
--------
wifi1
wifi2
(config)>
b. Set the appropriate radio:
(config)> network wifi ap digi_ap1 radio wifi1
(config)>
8. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has disconnected,
it will be able to use the group key to decrypt broadcast packets until the key is changed.
(config)> network wifi ap digi_ap1 encryption group_rekey value
(config)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
(config)> network wireless ap digi_ap1 encryption group_rekey 600s
(config)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected see all
broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
5. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
TX54 User Guide
Wi-Fi1 radio
Wi-Fi2 radio
for more information.
Configure a Wi-Fi access point with no security
Configure a LAN and
170