Digi TX54 User Manual page 468

Services
To enable the Iperf3 server:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > IPerf.
4. Click Enable.
5. (Optional) For Iperf Server Port, type the appropriate port number for the iPerf server
listening port.
6. (Optional) Click to expand Access control list to restrict access to the iPerf server:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's
d. Click  again to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 address or network that can access the device's
TX54 User Guide
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
service-type. Allowed values are:
Use the iPerf service
468