Digi TX54 User Manual page 595

Firewall
The Configuration window is displayed.
3. Click Firewall > Quality of Service.
4. Click to expand either Outbound or Inbound.
5. Enable the binding.
6. Select an Interface.
7. Examine the remaining default settings and modify as appropriate for your network.
8. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable one of the preconfiged bindings:
To enable the Outbound binding:
n
(config)> firewall qos 0 enable true
(config)>
To enable the Inbound binding:
n
(config)> firewall qos 1 enable true
(config)>
TX54 User Guide
Configure Quality of Service options
595