Table of Contents
Advertisement
Command line interface
In task two, we will assign the new LAN2 bridge to a LAN.
Note
The example command and output in this procedure are based on a dual-Wifi configuration.
Commands and output will vary slightly if your TX54 device is a single-WiFi model.
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Display a list of devices currently configured for the LAN1 bridge:
Method one: Enter the full command at the config prompt:
n
(config)> show network bridge lan1 device
0 /network/device/eth2
1 /network/device/eth3
2 /network/device/eth4
3 /network/wireless/ap/digi_ap1
4 /network/wireless/ap/digi_ap2
(config)>
Method two: Move within the configuration to the network bridge lan1 device location
n
and the use the show command display the list of devices:
a. Change to the network node:
b. Change to the bridge node:
c. Change to the lan1 node:
TX54 User Guide
(config)> network
(config network)>
(config network)> bridge
(config network bridge)>
(config network bridge)> lan1
(config network bridge lan1)>
Configuration mode
760
Advertisement
Table of Contents
