Example Performance Test Using Iperf3 - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

Where value is a firewall zone defined on your device, or the any keyword.

Repeat this step to list additional firewall zones.

6. Save the configuration and apply the change:

(config)> save

Configuration saved.

7. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Example performance test using Iperf3

On a remote host with Iperf3 installed, enter the following command:

$ iperf3 -c device_ip

where device_ip is the IP address of the TX54 device. For example:

$ iperf3 -c 192.168.2.1

Connecting to host 192.168.2.1, port 5201

4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201

[ ID] Interval

TX54 User Guide

Display a list of available firewall zones:

Type ... firewall zone ? at the config prompt:

(config)> ... firewall zone ?

Zones: A list of groups of network interfaces that can be

referred to by packet

filtering rules and access control lists.

Additional Configuration

---------------------------------------------------------

----------------------

dynamic_routes

224 Mbits/sec

238 Mbits/sec

250 Mbits/sec

262 Mbits/sec

269 Mbits/sec

Use the iPerf service