Table of Contents
Advertisement
Services
Configure telnet access
By default, the telnet service is disabled.
Note
Telnet is an insecure protocol and should only be used for backward-compatibility reasons, and
only if the network connection is otherwise secured.
Required configuration items
Enable telnet access.
n
Configure access control for the telnet service.
n
Additional configuration items
Port to use for communications with the telnet service.
n
Multicast DNS (mDNS) support.
n
See
Set the idle timeout for TX54 users
telnet service.
Enable the telnet service
The telnet service is disabled by default. To enable the service:
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > telnet.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.
TX54 User Guide
for information about setting the inactivity timeout for the
Configure telnet access
411
Advertisement
Table of Contents
