Digi TX54 User Manual page 286

Routing
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a VRRP instance. For example:
(config)> add network vrrp new_vrrp_instance
(config network vrrp new_vrrp_instance)>
4. Enable the VRRP instance:
(config network vrrp new_vrrp_instance)> enable true
(config network vrrp new_vrrp_instance)>
5. Set the interface on which this VRRP instance should run:
a. Use the ? to determine available interfaces:
(config network vrrp new_vrrp_instance)> interface ?
Interface: The network interface to communicate with VRRP peers on and
listen for traffic to virtual IP addresses.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan1
/network/interface/wwan2
Current value:
(config network vrrp new_vrrp_instance)> interface
b. Set the interface. For example:
(config network vrrp new_vrrp_instance)> interface
/network/interface/wan1
(config network vrrp new_vrrp_instance)>
6. Set the router ID. The Router ID must be the same on all VRRP devices that participate in the
same VRRP device pool. Allowed values are from 1 and 255, and it is configured to 50 by
default.
(config network vrrp new_vrrp_instance)> router_id int
(config network vrrp new_vrrp_instance)>
7. Set the priority for this router in the group. The router with the highest priority will be used as
the master router. If the master router fails, then the IP address of the virtual router is
mapped to the backup device with the next highest priority. If this device's actual IP address is
being used as the virtual IP address of the VRRP pool, then the priority of this device should be
set to 255 . Allowed values are from 1 and 255, and it is configured to 100 by default.
TX54 User Guide
Virtual Router Redundancy Protocol (VRRP)
286