Delete A Local User - Digi TX54 User Manual

User authentication
Where code is an digit number, with a minimum of 10000000.
iii. To add additional scratch codes, use the add end code command again.
8. Save the configuration and apply the change:
(config auth user new 2fa scratch_code)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a local user

To delete a user from your TX54:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Users.
4. Click the menu icon (...) next to the name of the user to be deleted and select Delete.
5. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
TX54 User Guide
Local users
536