Digi TX54 User Manual page 478

Applications
10. Click to enable Once to configure the script to run only once at the specified time.
If Once is enabled, rebooting the device will cause the script to not run again. The only way to
re-run the script is to:
Remove the script from the device and add it again.
n
Make a change to the script.
n
Uncheck Once.
n
11. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
4. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spaces are used, enclose value within double quotes.
5. Set the mode that will be used to run the script:
(config system schedule script 0)> when mode
(config system schedule script 0)>
where mode is one of the following:
TX54 User Guide
Configure applications to run automatically
478