Digi TX54 User Manual page 183

Hide thumbs Also See for TX54:

Table of Contents

b. Set the appropriate radio:

(config)> network wifi ap digi_ap1 radio wifi1

11. (Optional) Set the amount of time to wait before changing the group key.

The group key is shared by all in clients of the access point, and after a client has disconnected,

it will be able to use the group key to decrypt broadcast packets until the key is changed.

(config)> network wifi ap digi_ap1 encryption group_rekey value

where value is any number of days, hours, minutes, or seconds, and takes the format number

For example, to set group rekey interval to ten minutes, enter either 10m or 600s:

(config)> network wireless ap digi_ap1 encryption group_rekey 600s

Increasing the time between rekeys can improve connectivity issues in noisy environments. To

disable group rekeys, set to 0. This will allow any client that has previously connected see all

broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10

5. Assign the Wi-Fi access point to a LAN interface or to a bridge. See

Configure a bridge

The access point must be assigned to an active LAN, or a bridge that is assigned to an active

6. Save the configuration and apply the change:

(config)> save

Configuration saved.

7. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

TX54 User Guide

Configure a Wi-Fi access point with enterprise security

for more information.

Configure a LAN