Digi TX54 User Manual page 114

Interfaces
(config)> del network bridge lan1 device 4
(config)>
b. Remove the ETH4 device (/network/device/eth4) from the bridge, using its index number,
2, as determined above with the show command:
(config)> del network bridge lan1 device 2
(config)>
c. Remove the ETH3 device (/network/device/eth3) from the bridge, using its index number,
1, as determined above with the show command:
(config)> del network bridge lan1 device 1
(config)>
d. Use the show command again to verify that the LAN1 bridge now has only two devices,
ETH2 and Digi AP (Wi-Fi1):
(config)> show network bridge lan1 device
0 /network/device/eth2
1 /network/wireless/ap/digi_ap1
(config)>
5. Create a new bridge, named LAN2:
(config)> add network bridge LAN2
(config network bridge LAN2)>
6. Add devices to the bridge:
a. View available devices and the proper syntax by using the add device command with the
TAB autocomplete feature:
(config network bridge LAN2)> add device end <TAB>
(config network bridge LAN2)> add device end /network/<TAB>
/network/device/eth1
/network/device/eth3
/network/device/eth4
/network/bridge/LAN2
/network/bridge/lan1
/network/wireless/ap/digi_ap2
(config network bridge LAN2)>
b. Add the ETH3 device to the bridge:
(config network bridge LAN2)> add device end /network/device/eth3
(config network bridge LAN2)>
c. If your device is a dual-WiFi model, add the Digi AP (Wi-Fi2) access point to the bridge:
(config network bridge LAN2)> add device end /network/wireless/ap/digi_
ap2
(config network bridge LAN2)>
TX54 User Guide
/network/device/eth2
/network/device/loopback
/network/wireless/ap/digi_ap1
Local Area Networks (LANs)
114