Example: Configure Two Lans - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

9. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Example: Configure two LANs

The default configuration of the TX54 consists of one LAN (LAN1), which is configured to use the LAN1

bridge. Its default IP address is 192.168.2.1, and it has its DHCP server enabled. The default

configuration of the LAN1 bridge consists of the following devices:

WWAN cellular modem for single-Wi-Fi models, or WWAN2 cellular modem for dual-Wi-Fi models.

WWAN2 cellular modem (dual-Wi-Fi models only)

In this example, we will create a second bridge, called LAN2. We will then create a second LAN, LAN2,

and configure LAN2 to use the new bridge.

To avoid potential problems with access to the device while performing these procedures, you

should use an Ethernet connection connected to LAN1 through the ETH2 Ethernet port, or, if using the

command line, use the serial port.

Task one: Configure bridges

In this task, we will create a new bridge and configure the LAN1 and LAN2 bridges to use the following

LAN1 bridge:

WWAN cellular modem for single-Wi-Fi models, or WWAN2 cellular modem for dual-Wi-Fi

LAN2 bridge:

Digi AP (Wi-Fi2) (applicable to dual-WiFi models only )

In task two, we will assign the new LAN2 bridge to a LAN.

TX54 User Guide

Local Area Networks (LANs)