Delete A Port Forwarding Rule - Digi TX54 User Manual

Firewall
To specify the firewall zone for white listing:
n
(config firewall dnat 0 acl)> add zone end zone
Repeat for each appropriate zone.
To view a list of available zones:
(config firewall dnat 0 acl)> .. .. .. zone ?
Zones: A list of groups of network interfaces that can be referred to
by packet filtering rules
and access control lists.
Additional Configuration
---------------------------------------------------------------------
---------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config firewall dnat 0 acl)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a port forwarding rule

To delete a port forwarding rule:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
TX54 User Guide
Port forwarding rules
575