Table of Contents
Advertisement
Services
Configure the location server
The location server is enabled by default. You can disable it, or you can enable it if it has been disabled.
You can also optionally configure the UDP listening port for location information.
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. The location server is enabled by default. To disable, or to enable if it has been disabled, click
Enable the location server.
5. (Optional) For Location server port, type the port number that should be used to listen for
location messages. The default is 2948.
6. (Optional) Configure the Access control list:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's
d. Click again to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click .
TX54 User Guide
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
Location information
430
Advertisement
Table of Contents
