Services
11. (Optional) Set the privacy protocol, either DES or AES. The default is DES.
(config)> service snmp privacy_protocol AES
(config)>
12. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Download MIBs
This procedure is available from the WebUI only.
Required configuration items
Enable SNMP.
n
To download a .zip archive of the SNMP MIBs supported by this device:
WebUI
1. Log into the TX54 WebUI as a user with Admin access.
2. Enable SNMP.
See
Configure Simple Network Management Protocol (SNMP)
and configuring SNMP support on the TX54 device.
3. On the main menu, click Status. Under Services, click SNMP.
The SNMP page is displayed.
4. Click Download.
TX54 User Guide
Simple Network Management Protocol (SNMP)
for information about enabling
428