Digi TX54 User Manual page 153

Serial port
2. On the menu, click System. Under Configuration, click Serial Configuration.
The Serial Configuration page is displayed.
Note You can also configure the serial port by using Device Configuration > Serial. Changes
made by using either Device Configuration or Serial Configuration will be reflected in both.
3. Click to expand Port 1.
The serial port is enabled by default. To disable, toggle off Enable.
4. For Mode, select either Login or Remote.
Login: Allows the user to log into the device through the serial port.
n
Remote: Allows for remote access to another device that is connected to the serial port.
n
The default is Login.
5. (Optional) For Label, enter a label that will be used when referring to this port.
6. Click to expand Serial Settings.
7. For Baud rate, select the baud rate used by the device to which you want to connect.
8. For Data bits, select the number of data bits used by the device to which you want to connect.
9. For Parity, select the type of parity used by the device to which you want to connect.
10. For Stop bits, select the number of stop bits used by the device to which you want to connect.
TX54 User Guide
Configure the serial port
153