Digi TX54 User Manual page 706

Diagnostics
Log servers are enabled by default. To disable, click to toggle off Enable.
c. Type the host name or IP address of the Server.
d. Select the event categories that will be sent to the server.
5. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) To configure remote syslog servers:
a. Add a remote server:
(config)> add system log remote end
(config system log remote 1)>
b. Enable the server:
(config system log remote 1)> enable true
(config system log remote 1)>
c. Set the host name or IP address of the server:
(config system log remote 1)> server hostname
(config system log remote 1)>
d. The event categories that will be sent to the server are automatically enabled when the
server is enabled. To disable:
TX54 User Guide
Configure syslog servers
706