Digi TX54 User Manual page 78

Interfaces
iii. For Interface, select Interface: WWAN_Private.
6. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the maximum number of interfaces for the modem:
(config)> network modem wwan1 max_intfs 2
(config)>
4. Create the WWAN interfaces:
a. Create the WWANPublic interface:
(config)> add network interface WWANPublic
(config network interface WWANPublic)>
b. Set the interface type to modem:
(config network interface WWANPublic)> type modem
(config network interface WWANPublic)>
c. Set the modem device:
TX54 User Guide
Wide Area Networks (WANs)
78