Digi TX54 User Manual page 317

Hide thumbs Also See for TX54:
Table of Contents

Advertisement

Virtual Private Networks (VPN)
n
n
n
14. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
  Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new IPsec tunnel, or edit an existing one:
To create a new IPsec tunnel, see
n
To edit an existing IPsec tunnel, change to the IPsec tunnel's node in the configuration
n
schema. For example, for an IPsec tunnel named ipsec_example, change to the ipsec_
example node in the configuration schema:
TX54 User Guide
HTTP test HTTP test (IPv6): Tests connectivity by sending an HTTP or HTTPS GET
request to the URL specified in Web servers. The URL should take the format of
http[s]://hostname/[path].
Test DNS servers configured for this interface or Test DNS servers configured
for this interface (IPv6): Tests connectivity by sending a DNS query to the DNS
servers configured for this interface.
Test the interface status or Test the interface status IPv6: The interface is
considered to be down based on:
Down time: The amount of time that the interface can be down before this test
l
is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Down time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Initial connection time: The amount of time to wait for an initial connection to
l
the interface before this test is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Configure an IPsec
tunnel.
IPsec
317

Advertisement

Table of Contents
loading

Table of Contents