Digi TX54 User Manual page 174

Wi-Fi
wifi2
Current value:
(config network wifi ap new_AP)>
b. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
5. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
6. Set the security for the access point to psk or psk2 :
(config network wifi ap new_AP)> encryption type psk2
(config network wifi ap new_AP)>
7. Set the password that clients will use when connecting to the access point:
(config network wifi ap new_AP)> encryption key_psk2 password
(config network wifi ap new_AP)>
8. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has disconnected,
it will be able to use the group key to decrypt broadcast packets until the key is changed.
(config network wifi ap new_AP)> encryption group_rekey value
(config network wifi ap new_AP)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
(config network wireless ap new_AP)> encryption group_rekey 600s
(config network wireless ap new_AP)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected see all
broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
5. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
TX54 User Guide
Configure a Wi-Fi access point with personal security
for more information.
Configure a LAN and
174