Table of Contents
Advertisement
Services
b. Set the interface. For example:
(config service multicast test)> src_interface /network/interface/wan1
(config service multicast test)>
8. Set the destination interface that the TX54 device will use to send mutlicast packets.
(config service multicast test)> interface interface
(config service multicast test)>
a. Use the ? to determine available interfaces:
(config service multicast test)> interface ?
Destination interface: Which interface to send the multicast packets.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan1
/network/interface/wwan2
Current value:
(config service multicast test)> interface
b. Set the interface. For example:
(config service multicast test)> interface /network/interface/wan1
(config service multicast test)>
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
Configure a multicast route
462
Advertisement
Table of Contents
