Configure Custom Firewall Rules - Digi TX54 User Manual

Firewall
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure custom firewall rules

Custom firewall rules consist of a script of shell commands that can be used to install firewall rules,
ipsets, and other system configuration. These commands are run whenever system configuration
changes occur that might cause changes to the firewall.
To configure custom firewall rules:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Custom rules.
4. Enable the custom rules.
TX54 User Guide
Configure custom firewall rules
586