Table of Contents
Advertisement
Wi-Fi
4. Click to expand the appropriate Wi-Fi radio. For single-Wi-Fi models, there is only one radio
listed.
5. For Frequency band, select either 2.4 GHz or 5 GHz. Only channels appropriate for the band
are displayed.
6. For Access point mode, select the appropriate mode.
7. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set channel for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
------------------------------------------------------------------------
-------
wifi1
wifi2
(config)> network wifi radio
TX54 User Guide
Configure the Wi-Fi module band and protocol
Wi-Fi1 radio
Wi-Fi2 radio
163
Advertisement
Table of Contents
