Digi TX54 User Manual page 222

Hide thumbs Also See for TX54:
Table of Contents

Advertisement

Hotspot
b. Add the appropriate device. For example, to add the Digi AP (Wi-Fi) Wi-Fi access point:
(config network bridge new_hotspot_bridge)> add device end
/network/wireless/ap/digi_ap1
(config)>
7. Set an access point, and Ethernet port, or a bridge for the hotspot's device:
a. Determine available devices:
(config network hotspot new_hotspot)> device ?
Device: Device to use for this hotspot interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/bridge/new_hotspot_bridge
/network/wifi/ap/digi_ap1
/network/wifi/ap/digi_ap2
/network/wifi/ap/digi_hotspot_ap1
/network/wifi/ap/digi_hotspot_ap2
/network/wifi/ap/new_hotspot_ap1
/network/wifi/ap/new_hotspot_ap2
Current value:
(config network hotspot new_hotspot)>
b. Add the device:
(config network hotspot new_hotspot)> device /network/bridge/new_
hotspot_bridge
(config network hotspot new_hotspot)>
8. Set the authentication mode:
(config network hotspot new_hotspot)> auth value
(config network hotspot new_hotspot)>
where value is one of:
click_through: Requires each user to accept the terms and conditions.
n
local_shared_password: Requires each user to enter a password. This password is
n
validated locally on the TX54 device, and the password is the same for all users.
See
about configuring hotspot for local shared password authentication.
radius_shared_password: Requires each user to enter a password. This password is
n
validated by an external RADIUS server, and the password is the same for all users.
TX54 User Guide
Configure the hotspot to use local shared password authentication
Hotspot configuration
for information
222

Advertisement

Table of Contents
loading

Table of Contents