Table of Contents
Advertisement
Services
To limit access to hosts connected through a specified interface on the TX54 device:
n
(config)> add service telnet acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service telnet acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
TX54 User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
lan1
loopback
wan1
wwan1
wwan2
(config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
hotspot
internal
Default IP
Default Link-local IP
LAN1
Loopback
WAN1
WWAN1
WWAN2
Configure telnet access
415
Advertisement
Table of Contents
