Digi TX54 User Manual page 241

Hotspot

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show hotspot
> show hotspot
Hotspot
-----------
hotspot
new_hotspot
>
3. Enter the show hotspot name hotspot_name command at the Admin CLI prompt to display
information about clients connected to a specific hotspot:
> show hotspot name hotspot
MAC Address
sec %/max up bandwidth
-----------------
--- ------------------
8C-2D-2D-C8-41-AA
0/0
E5-8A-FC-D3-DC-7E
0/0
>
4. Enter the show hotspot ip ip_address command at the Admin CLI prompt to display
information about clients connected to a specific hotspot:
> show hotspot ip hotspot 10.1.0.101
MAC Address
sec %/max up bandwidth
-----------------
--- ------------------
8C-2D-2D-C8-41-AA
0/0
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
command at the Admin CLI prompt:
Enabled Device
------- --------------
true hotspot_bridge
false new_hotspot_ap
IP Address Auth
%/max down bandwidth
---------- ----
--------------------
10.1.0.101 yes
0/0
10.1.0.100 no
0/0
IP Address Auth
%/max down bandwidth
---------- ----
--------------------
10.1.0.101 yes
0/0
Show hotspot status and statistics
Username Duration/max sec
-------- ----------------
mariev 0/0
- 0/0
Username Duration/max sec
-------- ----------------
mariev 0/0
Idle/max
---------
0/0
0/0
Idle/max
---------
0/0
241