Digi TX54 User Manual page 337

Virtual Private Networks (VPN)
14. (Optional) Click to expand Advanced Options to manually set additional OpenVPN
parameters.
a. Click Enable to enable the use of additional OpenVPN parameters.
b. Click Override if the additional OpenVPN parameters should override default options.
c. For OpenVPN parameters, type the additional OpenVPN parameters.
15. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> add vpn openvpn server name
(config vpn openvpn server name)>
where name is the name of the OpenVPN server.
The OpenVPN server is enabled by default. To disable the server, type:
(config vpn openvpn server name)> enable false
(config vpn openvpn server name)>
4. Set the mode used by the OpenVPN server:
(config vpn openvpn server name)> device_type value
(config vpn openvpn server name)>
where value is one of:
tun: Routing mode. See
n
tap: Bridging mode. See
n
The default is tun.
5. Set the firewall zone for the OpenVPN server. For TUN device types, this should be set to
internal to treat clients as LAN devices.
TX54 User Guide
OpenVPN for information about TUN mode.
OpenVPN for information about TAP mode.
OpenVPN
337