Digi TX54 User Manual page 446

Services
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Location features are enabled by default. If they have been disabled, enable the appropriate
features:
Enable the TX54 device to forward information that it receives from external location
n
sources:
(config)> service location enable true
(config)>
See
information.
Configure the TX54 device to forward the device's location information based on its
n
GNSS module:
(config)> service location gnss true
(config)>
4. (Optional) Set the amount of time to wait to forward location information to remote hosts. The
default is ten seconds.
(config)> service location interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set the location update interval to ten minutes, enter either 10m or 600s:
(config)> service location interval 600s
(config)>
5. Add a remote host to which location messages will be sent:
(config)> add service location forward end
(config service location forward 0)>
6. Set the hostname or IP address of the remote host to which location messages will be sent:
(config service location forward 0)> server host
(config service location forward 0)>
7. Set the UDP port on the remote host to which location messages will be sent:
(config service location forward 0)> server_port 8000
(config service location forward 0)>
TX54 User Guide
Configure the device to accept location messages from external sources
Location information
for more
446