Digi TX54 User Manual page 766

Command line interface
-----------------------------------------------------------------------
--------
address
enable
gateway
metric
mgmt
mtu
type
weight
Additional Configuration
-----------------------------------------------------------------------
--------
connection_monitor
dhcp_relay
dhcp_server
dns
(config network interface WAN2)> ipv4
b. Enter ipv4 type ? to determine available settings for the ipv4 type:
(config network interface WAN2)> ipv4 type ?
Type: The method for configuring IPv4 on this interface.
Format:
dhcp
static
Default value: static
Current value: static
(config network interface WAN2)> ipv4 type
c. Set the IPv4 type to dhcp:
(config network interface WAN2)> ipv4 type dhcp
(config network interface WAN2)>
8. Configure the IPv4 WAN priority.
Because the TX54 device now has two WANs, we need to determine which WAN will be the
default route when both WANs are active. In this example configuration, WAN1 should be the
primary WAN, and WAN2 only used when WAN1 is down. Additionally, the Wireless WANs will
provide additional failover capabilities and will be used only when both WAN1 and WAN2 are
unable to connect to the internet.
To do this, we will set the metric for WAN2 to a value that is higher than the metric for WAN1,
and lower than the metric for the WWANs.
TX54 User Guide
Address
true Enable
Default gateway
0 Metric
0 Management priority
1500 MTU
static Type
10 Weight
Active recovery
DHCP relay
DHCP server
DNS servers
Configuration mode
766