Configure Power Button Behavior - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

System administration

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. To set the ignition power on delay:

(config)> system power ignition on_delay value

where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.

For example, to set the ignition power on delay to ten minutes, enter either 10m or 600s:

(config)> system power ignition on_delay 600s

The default is 0s, meaning that there is no power on delay.

4. To set the ignition power off delay:

(config)> system power ignition off_delay value

where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.

For example, to set the ignition power off delay to ten minutes, enter either 10m or 600s:

(config)> system power ignition off_delay 600s

The default is 0s, meaning that there is no power off delay.

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure power button behavior

The TX54 device's front panel includes a Power button.

If the device is off, pressing the Power button will turn on the device.

If the device is on, the Power button includes two options to power down the device: short-

press and long-press options. By default, both short-press and long-press Power button actions

will shut down the device.

You can disable the short-press power down behavior, to prevent powering down the device when the

Power button is accidentally pressed. You can also disable the power button entirely, so that both the

short- and long-press power down behavior is disabled and the device cannot be powered down by

using the Power button.

TX54 User Guide

Configure power button behavior