Digi TX54 User Manual page 118

Interfaces
7. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
Note The example command and output in this procedure are based on a dual-Wifi configuration.
Commands and output will vary slightly if your TX54 device is a single-WiFi model.
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new network interface named LAN2:
(config)> add network interface LAN2
(config network interface LAN2)>
4. Configure the device for the LAN2 interface:
a. Enter device ? to view available devices and the proper syntax.
(config network interface LAN2)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/LAN2
/network/bridge/lan1
/network/wireless/ap/digi_ap1
TX54 User Guide
Local Area Networks (LANs)
118