Digi TX54 User Manual page 214

Hotspot
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. (Optional) Create new access points for the hotspot.
You can also use existing access points for the hotspot. Access Points that are assigned to a
hotspot or to a bridge used by a hotspot cannot be used for any other purpose.
If more than one access point is being used by the hotspot, you must create a bridge that
includes the access points.
a. Click Configuration > Network > WiFi > Access points.
b. For Add WiFi access point:, type a name for the access point and click .
c. For Radio, select the appropriate Wi-Fi radio.
d. For SSID, type the SSID. Up to 32 characters are allowed.
This will be the SSID used by clients to connect to the hotspot. If you are creating multiple
access points, each access point must have the same SSID.
e. For Encryption, select Open (Unencrypted).
Hotspot access points must use open (unencrypted) communication. See
for more information.
f. Add additional access points by following the above instructions.
4. (Optional) Create a new bridge and interface for the hotspot.
Note Hotspot bridges must also be part of an interface with a configured IP address.
a. Click Network > Bridges.
b. For Add Bridge:, type a name for the bridge and click .
c. Add devices to the bridge:
i. Click to expand Devices.
ii. For Add device, click .
TX54 User Guide
Hotspot configuration
Hotspot security
214